321-779-9654
Unique and gorgeous plain brushed finish license plate frames (tag holders). These stainless steel license frames have the same finish as high quality stainless kitchen appliances. Made in the USA, completely in one plant for total quality control. Every brushed license plate frame kit comes complete with a variety of stainless steel and zinc coated hardware and matching snap cap covers for the ultimate installation and look. Guaranteed forever against rust! Also, there's no reason why a license plate frame should weigh nearly a pound (like cast frames). Frames are not sold by the pound, they are purchased for beauty and durability, neither of which is enhanced by adding unnecessary weight. Optional Plexiglas plate cover protects your registration decals from theft.
Click on small picture to enlarge and see other styles.
TABS: Every 2-hole frame we offer has tabs on the back to hold the license plate.
The brushed wide bottom license frames will cover the two bottom holes on your license plate and everything below. The notched frames have corners that are notched to allow lower vehicle registration stickers to show if your state places them there.
Please note: A variety of stainless steel and zinc coated screws are assorted and "non-specific" to any particular vehicle, but do accommodate most vehicles.
Standard size frames are approx. 6 3/8 x 12 3/8 inches. The wide bottom frames have a bottom width that measures 1 inch. Half-size frames are approx. 4 3/8 x 12 3/8 inches. The Half-Frames are for Half-Size logo plates. Plexiglass covers will not work with the half sized frames.
These are 304 stainless steel constructed license frames that have a brushed finish.
Frames are sold individually with a lifetime warranty.
PROUDLY MADE IN THE USA!
Click on small picture to enlarge and see other styles.
TABS: Every 2-hole frame we offer has tabs on the back to hold the license plate.
The brushed wide bottom license frames will cover the two bottom holes on your license plate and everything below. The notched frames have corners that are notched to allow lower vehicle registration stickers to show if your state places them there.
Please note: A variety of stainless steel and zinc coated screws are assorted and "non-specific" to any particular vehicle, but do accommodate most vehicles.
Standard size frames are approx. 6 3/8 x 12 3/8 inches. The wide bottom frames have a bottom width that measures 1 inch. Half-size frames are approx. 4 3/8 x 12 3/8 inches. The Half-Frames are for Half-Size logo plates. Plexiglass covers will not work with the half sized frames.
These are 304 stainless steel constructed license frames that have a brushed finish.
Frames are sold individually with a lifetime warranty.
PROUDLY MADE IN THE USA!
Question? Please EMAIL
